The installation requirements and standards of motors mainly involve the installation environment, installation location, installation base, etc. Only by installing it strictly following the requirements of motor standards can the normal operation of the motor be ensured and the service life of the motor extended.

1. Ambient temperature: -20-50℃ (no icing). If the temperature is too high or too low, it will affect the normal operation of the motor and even cause the motor to overheat and age.
2. Ambient humidity: below 85% (no knots), otherwise water vapor may appear inside the motor, thus affecting the normal operation of the motor.
3. Good ventilation: The installation location of the motor should fully consider the air circulation, and well-ventilated areas are more suitable for using the motor.
4. No corrosive gas: There should be no corrosive or oxidizing gases such as acid, alkali, etc. where the motor is installed.
5. The motor installation position must be stable, without shaking or looseness, to avoid abnormal noise and stop when the motor is running.

6. The installation of the motor base must comply with the motor specifications, the base size must match the motor size. The base load-bearing capacity must meet the motor's usage requirements and can withstand the vibration and impact generated when the motor is running.

Please note: In a sealed environment such as a control panel or near a heating element, the ambient temperature will rise. When installing the motor, be sure to set ventilation holes and pay attention to the increase in ambient temperature. Do not install it near a vibration source or in a place where vibration can easily affect the motor.